Siemens SR23EI28ME User Manual

en Troubleshooting
48
Fault Cause troubleshooting
Tea residue or lipstick marks
on tableware.
Too little detergent is being
used or is unsuitable.
▶
Use a suitable Detergent
→Page26 and follow the manufac-
turer's instructions for the amount
to be used.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food
and do not prerinse tableware.
Coloured coatings (blue, yel-
low, brown) that are difficult
or impossible to remove are
present inside the appliance
or on stainless steel table-
ware.
The formation of films is due
to substances contained in
vegetables (cabbage, celery,
potatoes, noodles, etc.) or
tap water (manganese).
▶
Clean the appliance.
You can remove deposits with
Mechanical cleaning →Page37 or
a machine cleaning product. It may
not always be possible to com-
pletely remove deposits but they
are harmless to health.
The formation of films is due
to metal components on sil-
ver or aluminium tableware.
▶
Clean the appliance.
You can remove deposits with
Mechanical cleaning →Page37 or
a machine cleaning product. It may
not always be possible to com-
pletely remove deposits but they
are harmless to health.
Coloured deposits (yellow,
orange, brown) that are easy
to remove are present inside
the appliance (mainly at the
bottom).
The formation of films is due
to ingredients of food rem-
nants and tap water (limes-
cale) "soaplike".
1. Check the setting of the water
softening system.
2. Add special salt.
→"Adding special salt", Page23
3. If you are using combined deter-
gents (tabs), activate the water
softening system.
Follow the information about deter-
gents.
→"Information on detergents",
Page28
Plastic parts inside the appli-
ance are discoloured.
Plastic parts inside the appli-
ance may become discol-
oured during the life of the
dishwasher.
▶
Discolouration can come about and
will not impair functioning of the ap-
pliance.
Plastic parts are discol-
oured.
Washing temperature is too
low.
▶
Select a programme with a higher
washing temperature.
→"Programmes", Page17

Siemens SR23EI28ME Specifications

General

Door color	Stainless steel
Cord length	1.75 m
Product size	Slimline (45 cm)
Inlet hose length	1.65 m
Custom panel-ready	Yes
Outlet hose length	2.05 m
Appliance placement	Freestanding
Current	10 A
AC input voltage	220-240 V
AC input frequency	50\\60 Hz
Energy efficiency scale	A to G
Water consumption per cycle	9.5 L
Cycle time	210 min
Noise level	44 dB
Delay start (max)	24 h
Overflow protection	-
Dishwashing programs	60min 65°C, Auto 45-65°C, Eco 50°C, Intensive 70°C, Standard 60°C
Number of place settings	10 place settings
Number of washing programs	6
Number of temperature settings	4
Package weight	43200 g

Weight and Dimensions

Depth	600 mm
Width	450 mm
Height	845 mm
Weight	41996 g
Depth with door open	1155 mm