Siemens Siemens
Siemens Siemens
Siemens
IndustryIndustry
IndustryIndustry
Industry
,,
,,
,
Inc. Inc.
Inc. Inc.
Inc.
Building Building
Building Building
Building
TT
TT
T
ecec
ecec
ec
hnologies Dihnologies Di
hnologies Dihnologies Di
hnologies Di
visionvision
visionvision
vision
P/N 315-048733-10
System Status Display with Control
Installation Instructions
Models SSD-C / SSD-C-INTL
INTRODUCTION The Model SSD-C/SSD-C-INTL from
Siemens Industry, Inc., is an optional
FireFinder module that displays the
event status of a system and has the
capability to control the system
remotely from the PMI/PMI-2/PMI-3
(XLS), FCM2041-U2 (Desigo Fire
Safety Modular), FCM2041-U3
(Cerberus PRO Modular). It has four
40-character alphanumeric LCD
character lines, backlit upon status change or display toggling. This module is super-
vised by the main panel and also has LEDs and an optional sounder to indicate the
status of the system. The SSD-C has the capability to store up to 1500 event mes-
sages and has pushbuttons to scroll through these events. Its display is independent
from the display on the PMI/PMI-2/PMI-3 (XLS), FCM2041-U2 (Desigo Fire Safety
Modular), FCM2041-U3 (Cerberus PRO Modular). During the SSD-C/SSD-C-INTL initial
power up, the SSD-C/SSD-C-INTL is configured in Display-only mode.
The following items are supplied with the SSD-C/SSD-C-INTL:
• SSD mounting plate (P/N 300-034289) with the SSD-TB interface board
(P/N 515-034170)
• 8-pin wiring interface cable (P/N 555-134347)
• SSD-C housing (P/N 195-134170) with an SSD-C-main board (P/N 557-034170)
• Overlay—The SSD-C has one overlay, the SSD-C-INTL has three overlays.
- SSD-C overlay (P/N 200-134294 in English)
- SSD-C-INTL overlays (P/N 200-134751 in French, P/N 200-134752 in
Spanish, P/N 200-134753 in Portuguese)
• 4 screws to mount the housing to the mounting bracket (P/N 545-634442)
The SSD-C-INTL is used in applications where French, Spanish or Portuguese is the
primary language. It is identical to the SSD-C in all other ways, and will be referred to
in the remainder of this document as SSD-C.
OPERATION The SSD-C has six LEDs and a sounder to indicate the status of the fire alarm panel.
The LCD indicates the state of a specific event. The SSD-C also has push buttons
that allow the user to scroll through the events list, and/or take control of the system.
The SSD-C can be configured as Display only or with System Control and can be
used in two different vectoring applications: No Vectoring and Queue Vectoring.Refer
to the Programming section on page 7 for information on configuring the system.
Figure 1
SSD-C System Status Display
AUDIBLES
SILENCED
ON
SUPERVISORY
ALARM
RESET
TROUBLE
SECURITY
ON
OFF
ACKNOWLEDGE
SILENCE
UNSILENCE
BUTTON ENABLE
To Next Page
Need help?
General
