Siemens Synco living - Door; Window Contact Wave AP 260 and DELTA Reflex Smoke Detector

89 / 100
Siemens Synco™ living Operating instructions CE1B2707en
Building Technologies Service 23.08.2008
Insert the new batteries. Ensure that
polarity is correct!
Replace the battery compartment
cover.
+
+
+
2707Z28
+
+
+
+
2707Z29
a
b
Dispose of the old batteries in compli-
ance with environmental regulations.
2707Z27
After insertion of the new batteries, the batteries’ capacity is checked. During
the check, the green LED lights up for 2 seconds, provided the batteries have
sufficient capacity.
After the check, the radiator control actuator checks its settings as a master or
slave. If set as a master, the red and green LED flashes 3 times; if set as a
slave, the LED remains dark. Then, the device will perform automatic calibra-
tion.
After that, the device will assume Normal operation.
Door / window contact wave AP 260 and
DELTA reflex smoke detector
For changing the batteries of the door / window contacts and the DELTA reflex
smoke detectors, please refer to the Operating and Mounting Instructions
supplied with these devices.