Need help?Do you have a question about the Siemens Synco RMU720 and is the answer not in the manual?
General| Type | Room controller |
|---|---|
| Power Supply | 24 V AC/DC |
| Operating Voltage | 24 V AC/DC |
| Communication Protocol | KNX |
| Digital Inputs | 4 (shared with universal inputs) |
| Operating Temperature | 0°C to +45°C |
| Universal Inputs | 4 (configurable as digital or analog) |
| Digital Outputs | Up to 4 (depending on configuration) |
Lists Synco devices with TP1 (wired) KNX interface and their applications.
Describes the three-level structure of a full-scale KNX network.
Explains how device addresses are assigned within an area and line.
Discusses the use and function of area/line couplers and IP routers in KNX networks.
Outlines the procedure for designing a KNX network, including site assessment and planning.
Specifies the maximum number of bus devices allowed on a line, area, and the total network.
Details the necessity and types of bus power supply for KNX communication.
Describes the procedure for commissioning Synco 700 controllers using RMZ operator units.
Step-by-step guide to setting device addresses using RMZ790 and RMZ791 operator units.
Detailed procedure for addressing devices using the OCI700.1 service tool.
Focuses on setting device addresses for RM controllers via ACS Service.
Setting device addresses for OZW771.xx central communication units.
Details on setting the device address for OZW775 central communication units.
Setting the device address for QAX910 central apartment units.
Setting device addresses for RXB/RXL room controllers.
Setting device addresses for QAW740 room units.
Setting device addresses for RMZ792 bus operator units.
Setting zone addresses using RMZ operator units for RM controllers.
Using ACS Service for efficient zone addressing, especially in extensive networks.
Key considerations for designing and commissioning large KNX plants.
Using ACS software for engineering large plants and managing addresses.
Overview of common faults and errors, focusing on communication issues.
Lists specific error codes and their meanings related to KNX bus communication.
How to configure heating/cooling changeover for 2-pipe systems.
Linking multiple controllers for coordinated room control.
Measures for protecting against lightning, overvoltage, and EMC.
Guidelines for external and internal lightning protection systems.
Details on surge protectors for mains and KNX networks.
To Next Page