Need help?Do you have a question about the Siemens Synco RMU730 and is the answer not in the manual?
General| Power Supply | 24 V AC/DC |
|---|---|
| Frequency | 50/60 Hz |
| Digital Inputs | 8 |
| Analog Inputs | 2 |
| Relay Outputs | 2 |
| Triac Outputs | 2 |
| Display | LCD |
| Dimensions | 90 x 90 x 60 mm |
| Type | Controller |
| Communication | Modbus RTU |
| Humidity Range | 5 to 95 % |
| Storage Temperature | -20 to +70 °C |
Provides an introductory overview of Synco and the KNX network, including the KNX Association's role.
Lists Synco devices with KNX TP1 interface for LTE mode communication.
Describes the three-level structure of a full-scale KNX network with area lines, main lines, and lines.
Outlines the procedure for designing a KNX network, including steps and criteria.
Details the concept and application of bus power supply (DPSU and PSU) for KNX.
Lists essential checks before starting the commissioning process for KNX devices.
Focuses on reading and assigning area, line, and device addresses for RM controllers.
Provides a step-by-step guide for setting device addresses using RMZ790/RMZ791 operator units.
Introduces the OCI700.1 service tool and ACS7 software for commissioning and diagnostics.
Focuses on modifying the factory-set device address for RM controllers.
To Next Page