29/120
Building Technologies Basic documentation: Communication via the KNX bus CE1P3127en
HVAC Products Device address and device name 30.08.2007
4 Device address and device name
4.1 RM… controllers
The RMZ790 and RMZ791 operator units are identical for the purpose of access to
the RM… controllers and in terms of their application and functions.
The RMZ792 bus operator unit, which has the same mechanical design as the
RMZ791, is used for remote access to the Synco 700 bus devices and in terms of
application and functions it differs substantially from the RMZ790 and RMZ791
operator units.
4.1.1 Reading the area, line and device address
The area, line and device address are factory-set in the RM… controllers. The
settings can be read with the RMZ790 and RMZ791 operator units at the Service
level (indicated by the
symbol).
From the start page, press the OK knob for access to the "Main menu" (see
illustration below).
On delivery from the factory, the start page displays the word "Welcome" instead of
the device name.
The bottom of an operating page is indicated by the "Arrow Up" symbol. For access
to the top of the page, the knob is rotated counter-clockwise.
The path for access to the "Basic settings" page containing the factory-set
addresses is as follows:
Main menu > Device information > Communication > Basic settings
Introduction
Start page:
Selecting the main menu
Note
Main menu
Note
Path to the "Basic
settings" page
Device information
Wednesday 28.05.2003 15:06
Welcome
« Information
Main menu »
Main menu
Time/date…
Faults…
Settings
Device information
Device information
Controller…
Extra configuration
Communication…
To Next Page
Loading...
