TC35i: Migration from TC35 to TC35i
PRELIMINARY
TC35_TC35i_MIG_01_V01.01 29.1.2003 Page 29 of 34
# AT Command
TC35i
Additional storage in ME memory for 25 SMS:
<mem1> Messages to be read and deleted from
this memory storage:
"SM" SIM message
storage
"ME" Mobile Equipment
message storage
"MT" Any of the storages
associated with ME
<mem2> Messages will be written and sent to this
memory storage:
"SM" SIM message
storage
"ME" Mobile Equipment
message storage
"MT" Any of the storages
associated with ME
<mem3> Received messages will be placed in this
memory storage if routing to TE is not set. See
command AT+CNMI with parameter <mt>=2.
"SM" SIM message
storage
"MT" Any of the storages
associated with ME
<usedx>Number of messages currently in
<memx>
<totalx>Number of messages storable in
<memx>
Note:
The Mobile Equipment storage "ME" has space for
25 short messages.
The storage "MT" is the sum of the storages "ME"
and "SM". The indices (<index>) from 1 to 25 are
associated to the "ME" storage. Indices equal to
26 and higher belong to the "SM" storage.
Incoming short messages with message class 1 or
2 (refer <dcs> GSM 03.38) will be stored in the
"ME" or "SM" storage only. Therefore the ^SMGO:
2 indication (see AT^SMGO) could occur, without
the indication ^SMGO: 1 before.
When switching parameter <mem3> from ''MT'' to
''SM'' the ''ME'' storage will be filled with dummy
short messages. Therefore the execution can last
up to 35 seconds if all the 25 records have to be
written.
When switching back from ''SM'' to ''MT'' the
dummy short messages will be deleted. The
execution could last 35 seconds, too.
In case of short messages present in the ''ME''
storage they will be remembered when switching
back from ''SM'' to ''MT''.
The <mem1>, <mem2> and <mem3> parameter
will be stored in non-volatile memory.
Multiplexer: The parameter <mem3> will be the
same for all instances. The parameter
<mem2> and <mem3> can differ from one
instance to the other.
TC35
Only "SM" storage available:
<mem1> Memory to be used when listing, reading
and deleting messages:
"SM" SIM message storage
<mem2> Memory to be used when writing and
sending messages:
"SM" SIM message storage
<mem3> Received messages will be placed to this
storage if routing to TE is not set. See AT+CNMI
command with parameter <mt>=2 (Chapter 5.10).
"SM" SIM message storage
<usedx> Number of messages currently in
<memx>
<totalx> Number of messages storable in <memx>
Note:
-
133 AT+CSCA SMS service centre address
134 AT+CSCB Select cell broadcast message
135 AT+CSDH Show SMS text mode parameters
136 AT+CSMP Set SMS text mode parameter
137 AT+CSMS Select Message Service
Differing implementation related to GSM phase 2+ compatibility issues and +CNMA
requirements; differing notes
To Next Page
Loading...
Need help?
General
