EasyManua.ls Logo

Siemens WM14LPH0ES - Saving the Programme Settings; Loading Laundry; Adding Detergent and Care Product; Starting the Programme

Siemens WM14LPH0ES
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en Basic operation
40
Observe the information about op-
erating logic.
Notes
¡ The programme settings are not
saved permanently for the pro-
gramme.
¡ The setting is saved if you activate
or deactivate the intelligent dosing
system.
13.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme has been set.
¡ The programme settings have
been adjusted.
Press and hold for approx. 3
seconds.
Press to call up the saved pro-
gramme.
Note:To overwrite the saved pro-
gramme, repeat the steps above.
13.5 Loading laundry
Notes
¡ Observe the information on safety
→Page4 and preventing material
damage →Page10.
¡ To prevent creasing, take note of
the maximum load for the
→"Programmes", Page26.
Requirement:The laundry is pre-
pared.
→"Laundry", Page36
1. Open the door.
Make sure that the drum is empty.
2. Place the laundry in the drum.
3. Close the door.
Ensure that there is no laundry
trapped in the door.
13.6 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Note:Observe the information on
safety →Page4 and preventing ma-
terial damage →Page10.
Tip:In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note:Observe the information about
detergents and care products
→Page38.
1. Pull out the detergent drawer.
2. Pour in detergent.
→"Detergent drawer", Page18
3. If required, add the care product.
4. Push in the detergent drawer.
13.7 Starting the programme
Note:If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press ⁠ .
a The display shows either the pro-
gramme duration or the "Ready in"
time.
13.8 Adding laundry
Note:Observe the information on
safety →Page4 and preventing ma-
terial damage →Page10.
1. Press ⁠ .
The appliance pauses.

Table of Contents

Related product manuals