Siemens WM14LPH0ES - Remote Start; Data Protection

HomeConnect en
47
16.8 Remote start
Enable the appliance for remote start
via the HomeConnect app.
Activating remote start
Notes
¡ Remote start is deactivated for
safety reasons in the following
circumstances:
– Open the appliance door.
– Press ⁠ .
– Press .
– Switch off the appliance.
– Following a power cut.
¡ Remote start cannot be activated
for safety reasons in the following
circumstances:
– The appliance door is open.
– The detergent drawer has not
been pushed in fully.
Requirements
¡ The appliance is connected to your
Wi-Fi home network.
¡ The appliance is connected to the
HomeConnect app.
¡ A programme is selected.
▶
Press .
If you press and hold the button
for at least 3seconds, the
HomeConnect menu opens.
If you briefly press the button, the
appliance is enabled for remote
start via the HomeConnect app.
If you open the appliance door, the
function is automatically deactiv-
ated.
a lights up.
Note:To deactivate the function,
press .
16.9 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the HomeConnect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
¡ Security certificate of the Wi-Fi
communication module (to ensure
a secure data connection).
¡ The current software and hardware
version of your appliance.
¡ Status of any previous reset to
factory settings.
This initial registration prepares the
HomeConnect functions for use and
is only required when you want to
use the HomeConnect functions for
the first time.
Note:Please note that the
HomeConnect functions can only be
utilised with the HomeConnect app.
Information on data protection can be
retrieved in the HomeConnect app.