Siemens WM14LPH0ES - Filling the Dispensers; Dispenser Contents

Intelligent dosing system en
43
2. If required, adjust the contents of
the dispenser →Page43.
3. If required, adjust the basic
dosage →Page44.
4. If required, adjust the programme
settings →Page39.
5.
Start the programme →Page40.
6. The
→"Unloading the laundry",
Page41.
15.2 Filling the dispensers
If you want to use the intelligent dos-
ing system or if the appliance dis-
plays a message during operation of
the appliance, fill the dispensers.
Notes
¡ Observe the information on safety
→Page4 and preventing material
damage →Page10.
¡ Fill the dispensers only with suit-
able detergent and care products
→Page38.
If you want to add more liquid de-
tergent or fabric softener in the dis-
penser, use the same product.
If you want to replace the liquid de-
tergent or fabric softener in the dis-
penser with another product, clean
the detergent drawer beforehand.
→"Cleaning the detergent drawer",
Page49
1. Pull out the detergent drawer.
2. Open the dispenser cover.
3. Pour liquid detergent ⁠ and fab-
ric softener ⁠ into the relevant dis-
pensers.
→"Detergent drawer", Page18
Do not exceed the marking for the
maximum filling level when filling.
4. Close the dispenser cover.
Note:To prevent the liquid deter-
gent or fabric softener from drying
out, close the dispenser cover im-
mediately after filling.
5. If required, add cleaning aids such
as stain remover, water softener or
bleach into the compartment for
manual dosing.
→"Adding detergent and care
product", Page40
6. Push in the detergent drawer.
7. Adjust the basic dosage
→Page44.
15.3 Dispenser contents
Notes
¡ If you change the contents of the
dispenser, the basic dosage for
this dispenser is reset.
¡ If you use both dispensers for li-
quid detergent, you must select a
dispenser which is to be used dur-
ing washing.
Adjusting the dispenser contents
1. Press and hold ⁠ i-Dos for ap-
prox. 3 seconds.