Siemens WM14LPH0ES - Connecting the Appliance to the Home Connect App; Activating Wi-Fi on the Appliance; Deactivating Wi-Fi on the Appliance; Software Update

en HomeConnect
46
16.3 Connecting the appli-
ance to the HomeCon-
nect app
Requirements
¡ The appliance is connected to the
WLAN home network (Wi-Fi).
¡ The HomeConnect app is open
and you have logged on.
1. Set the programme to position3.
a The display shows APP.
2. Press ⁠ .
a The appliance connects to the
HomeConnect app.
3. Once your appliance is displayed
in the HomeConnect app, carry
out the last steps in the
HomeConnect app.
a If the display shows con, the appli-
ance is connected to the
HomeConnect app.
16.4 Activating Wi-Fi on the
appliance
Note:When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1. Press and hold for approx. 3
seconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press ⁠ repeatedly until the dis-
play shows on.
a Wi-Fi is activated.
16.5 Deactivating Wi-Fi on the
appliance
1. Press and hold for at least
threeseconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press ⁠ repeatedly until the dis-
play shows oFF.
a Wi-Fi is deactivated.
Note:The connection is automatically
re-established when the Wi-Fi is
switched back on.
16.6 Software update
Requirement:The display shows
1. Press and hold for approx. 3
seconds.
2. Set the programme to position6.
a UPd appears on the display.
3. Press ⁠ .
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note:Do not switch off the appliance
while the software update is in pro-
gress.
16.7 Resetting the appliance
network settings
1. Press and hold for at least
3seconds.
2. Set the programme to position5.
a The display shows rES.
3. Press ⁠ .
a The display shows Yes.
4. Press ⁠ .
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.