Sigma 2-5 - Page 35

Operating Manual SIGMA 2-5, page 35 of 55
03/06
4.2.2 Time
Depending on the run mode this area indicates the total set time, the remaining
run
time or the elapsed time.
The time value as well as different run modes can be set by turning the left knob,
even during centrifugation.
If the time is changed during centrifugation, the total newly entered period is run.
the time elapsed before is not considered.
4.2.3 Standard Run Mode
For the standard run mode the time is set in minutes by turning the left knob
("min" is displayed).
This total run time (max. 30 minutes) is displayed by a sequence of bars before
starting the centrifuge.
During centrifugation this time is counted down, the sequence of bars indicates
the remaining run time. The set time is indicated by one single bar.
The centrifuge run can be early terminated by pressing the Stop-key. The set
time and the remaining run time remain on the display.