Operating Manual SIGMA 2-5, page 34 of 55
03/06
4.2.1.2 Relative Centrifugal Force (RCF)
The relative centrifugal force (RCF) is the acceleration which the sample is
exposed to.
The lower scale of the right area indicates the RCF value x 1000. This can be set
by turning the right knob.
After entry of a RCF value a single bar indicates the set speed.
A sequence of bars indicates the actual RCF value during a run.
The RCF value can be changed during a run by turning the right knob.
If during the run the RCF value is set below the actual value, the new set RCF
value is indicated by a flashing bar.
Please refer to chapter 1.2 “Suitable accessories“ for the maximum values for the
used rotor combination. For this example rotor combinations 11035 and 11032
have been chosen.
To Next Page
Loading...
