Operating Manual SIGMA 3-16K, page 44 of 69
03/06
4.2.1.1 Speed
The display “Speed“ shows the rotations per minute. This value can be set by
turning the right knob. Preselection of 1 rpm by pressing and holding (2 – 3
seconds) the stop key.
The actual speed is displayed below the set value.
Activate “set“ in the “Speed“ area by turning the left knob. The speed value can
be changed during the run by turning the right knob.
4.2.1.2 Relative Centrifugal Force (RCF)
The relative centrifugal force (RCF) is the acceleration which the sample is
exposed to.
The display “rcf“ shows the rcf-value. Activate “set“ in the “rcf“ area with the left
knob. The rcf value can be changed by turning the right knob. This is also
possible when the centrifuge is running. Preselection of 1 x g by pressing and
holding (2 – 3 seconds) the stop key.
Please refer to chapter 1.2 “Suitable accessories“ for the maximum values for
the used rotor combination.
To Next Page
Loading...
