Sigma 3-16K - General Information; Technical Data; Suitable Accessories; Safety Instructions

Operating Manual SIGMA 3-16K, page 7 of 69
03/06
General Information
1.1 Technical data
1.2 Suitable accessories
1.3 Scope of supply
1.4 Standards and regulations
1.5 Safety instructions
1.6 Symbol table
Description of the Centrifuge
2.1 General outlay
2.2 Construction and constructive safety measures
2.3 Drive
2.4 Operation and display
2.5 Electronics
2.6 Safety devices
2.6.1 Lid lock, cover closing device
2.6.2 Standstill monitoring
2.6.3 System check
2.6.4 Ground wire check
2.6.5 Imbalance Monitoring System
Installation and Start-up
3.1 Unpacking of the centrifuge
3.1.1 Transport safety device
3.2 Installation
3.2.1 Site
3.2.2 Connection
3.2.3 Fuses / emergency circuit breaker on site
3.3 Installation of rotors and accessories
3.3.1 Fastening of angle rotors with hermetically sealed lid
3.4 Initial start-up
3.4.1 Switching on of the centrifuge
3.4.2 Opening of the lid
3.4.3 Installation of a rotor
Operating Elements
4.1 Operating panel
4.1.1 Start-key / Saving a program
4.1.2 Stop-key with preselection of the soft stop and/or soft start function
4.1.3 Lid-key
4.1.4 Knobs