Page 130
Programming Worksheet
Appendix D
6. Enter a SITE IDENTIFICATION:_________________________________
7. Enter unit of measure for TOTAL FLOW (acre-feet, cubic feet, gallons,
liters, cubic meters):__________
Applies to velocity models only:
8. Enter the VELOCITY DIRECTION (Upstream (normal), Downstream or
Always Positive):__________
9. Enter the VELOCITY UNITS (fps or m/s):__________
10. Enter the VELOCITY CUTOFF:
Cutoff value = ______________, Default Value = ______________
OPTIONS MENU
From the Main Menu, select
OPTIONS.
1. Set Time & Date: __________
2. Level Sensor (Ultrasonic or Submerged Sensor): __________________
ADVANCED OPTIONS MENU
From the Main Menu, select
OPTIONS > ADVANCED OPTIONS.
1. Setup 4–20 ma Outputs (if desired):__________
2. Setup ALARMS (if desired):__________
Alarm Name High Trigger Low Trigger Deadband Time Interval Relay # Set
Low Mem Battery
Level
Flow
Flow Rate of Change
pH
Temperature
Rainfall
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
To Next Page
Loading...