Need help?Do you have a question about the Signode AL-12/38 and is the answer not in the manual?
General| Brand | Signode |
|---|---|
| Model | AL-12/38 |
| Category | Packaging equipment |
| Language | English |
Hazards from improper strap operation or sharp corners leading to injury.
Emphasizes proper training for tool operation and seeking guidance.
Risk of severe eye injury or blindness from not wearing safety glasses.
Danger of falling due to improper footing or balance while operating the tool.
Risk of cuts to hands or fingers when handling strap or sharp parts.
Daily inspection, cleaning, and lubrication of moving parts for tool maintenance.
Maintaining uncluttered and well-lighted work areas for safe operation.
Inspect and ensure proper double-notch seals for strap security.
Follow industry practices for safe material handling of strapped loads.
Use designated cutters and read instructions for safe strap cutting.
Weekly lubrication and daily cleaning of tool parts like feedwheel and clutch plug.
Details strap width, thickness, and seal type for the AL-38 model.
Details strap width, thickness, and seal type for the AL-12 model.
Procedure for inserting stacks of seals into the tool's magazine.
Step-by-step guide on encircling packages and applying tension to the strap.
Instructions for reassembling the ejector lever and related components.
Guide for removing and replacing the feedwheel and associated parts.
Steps for removing and installing a new gripper plug, including alignment.
Steps for taking apart the sealer mechanism and magazine assemblies.
Procedures for putting the sealer mechanism and magazine back together.
Steps for removing the ejector and lever without removing the magazine.
Detailed steps for disassembling the ejector component of the tool.
To Next Page
