4
Signode tools and machines are
designed and warranted to work together
with Signode strapping and seals. Use of
non-Signode strap, seals and/or
manufactured or specified replacement
parts may result in strap breakage or
joint separation while applying strapping
to a load or during normal shipping and
handling. This could result in severe
personal injury.
When using 3/4 x .031 (19 x 0.79mm)
strapping, tool conversion kit, part
#306815, must be installed. Failure to
install this kit could result in poor
performance, component failure or an
improperly formed seal which does not
have four (4) good notches. See Page 17
for additional information and details.
TABLE OF CONTENTS Page
General Safety Information 2
Specifications 4
Operating Instructions 5
Sealing Operation 6
Joint Formation 7
Parts Replacement 8
Maintenance 9
Parts List 10
Troubleshooting 15
Tool Options 17
AM-12, Part No. 023230
AM-58, Part No. 023220
AM-34, Part No. 023200
SPECIFICATIONS
STRAP
MODEL TYPE WIDTH THICKNESS SEALS
AM-12
APEX
&
MAGNUS
½"
(12.7mm) .015" - .023"
(.38mm - .58mm)
12AMP
AM-58 5/8"
(15.8mm)
58/34AMP
AM-34
3/4"
(19.1mm)
.015" - .025"
(.38mm - .64mm)
AM-3431* .015" - .031"
(.38mm - .79mm)
* Review Warning information above regarding .031" (.79mm) strapping.
To Next Page
Loading...
