24StartInitNX2.DOC Page 2 Latest update: 30 Jan -03
2.41 Locking the network for unauthorised change of set up
and calibration.
The Locking function gives the owner the possibility to prevent unauthorised users to enter the
Set up, Calibration or to move and select sub functions for the whole NX2 System.
To lock, long (2 sec.) on “Set” to enter Set up mode.
Press “Set” and “Page” simultaneously .
Enter the code 324135 by + and – button and press Set to lock.
To unlock, press “Set” and “Page” simultaneously while “LOCKEd” is displayed when entering
the Set up.
Then, enter the code 324135 by + and – button and press Set to unlock.
Note! To lock or unlock from the Wind Data or Compass Data “Set” has to be pressed after
entering three digits 324 and then again after 135 as well.
Note! GPS Navigator Instrument can not be used to lock or unlock.
To Next Page
Loading...