- 5 -
Description of the appliance
1 Thread tree
2 Thread tension selector (lower looper)
3 Spool support
4 Cold air intake
5 Connection Footpedal/Power supply
6 Handwheel
7 Power switch (On/Off switch)
8 Front flap
9 Arm support
0 Free arm
q Thread tension selector (left needle)
w Thread tension selector (right needle)
e Thread tension selector (upper looper)
r Thread guide
t Thread guide plate
z Adjustment wheel for stitch length
u Adjustment wheel for differential feed motion
i Adjustment wheel for cutting width
o Sewing foot
p Lower blade
a Upper blade
s Upper looper
d Lower looper
f Release lever PUSH
g Connection plug
h Foot pedal
j Power plug
k Waste container
Preparation
Place the overlock sewing machine on a stable and
level surface. Ensure there is sufficient illumination at
your workplace.
Adjusting the thread tree
Completely withdraw the thread tree 1 before
threading.
Turn the thread tree 1 so that the thread guides
stand exactly above the spool supports 3.
Bobbin supports
Both industrial bobbins and household bobbins can
be used with this machine.
For industrial bobbins with a large diameter place
the bobbins supports in with the broad end to the
top, for bobbins with a small diameter place the
support in with the narrow end to the top.
To Next Page
Loading...
