- 6 -
Bobbin caps
If using non-industrial thread bobbins, remove the
bobbin supports and place the bobbin caps on the
thread bobbins.
Connecting the foot pedal
Insert the plug of the footpedal g into the connection
for the footpedal 5 and the power plug j into a
mains power socket.
To switch the machine on, press the power switch 7.
Attention!
During absences from the machine or when doing
maintenance work, always remove the plug j from
the mains power socket. Injury hazard!
Controlling the sewing speed
The sewing speed is controlled by means of the
footpedal h. The sewing speed is changed by ap-
plying more or less pressure to the footpedal h.
Safety switch
This machine is fitted with a micro safety switch. You
cannot start the machine if the front flap 8 is open.
Close the front flap 8 before you start to sew.
Fitting the waste container
The waste container k collects remnants during
sewing, so that your workplace stays tidy. Place the
waste container k between the machine and the
table.
Handwheel
Note:
Always turn the handwheel 6 towards yourself,
that is, in the same direction as with a domestic
sewing machine.
Front flap
To open the front flap 8, slide it as far as possible
to the right and, at the same time, draw it towards
yourself.
To Next Page
Loading...
