To Next Page

To Previous Page

│

11 ■

SBDB 5 A1

Connecting the power supply

CAUTION

► Before connecting the device, compare the connection data on the

nameplate of the mains adapter (voltage and frequency) with those of your

mains supply. This data must agree so that the device is not damaged.

♦ Connect the supplied mains adapter to the mains adapter connection

and to a mains socket. The device is now in standby mode.

Inserting batteries

NOTE

► The device can be operated either with batteries or via the mains power

connection.

► Use 6 x 1.5V type C/Baby/LR14 batteries (not supplied) for battery

operation.

► When the battery level is low, you will hear a beep and the display

shows Battery low.

♦ Open the battery compartment

e on the rear of the device by turning

the two catches w of the battery compartment e anticlockwise until the

battery compartment e can be opened. Note also the labels OPEN and

CLOSE with the corresponding arrows on the catches w of the battery

compartment e.

♦ Insert 6 x 1.5V type C/Baby/LR14 batteries (not included) into the battery

compartment

e. Insert the batteries into the battery compartment e as

shown on the polarity diagram. Make sure that the strip is placed under the

batteries so that they can be easily removed again.

♦ Close the battery compartment

e on the rear of the device and turn the

two catches w of the battery compartment e clockwise into the locked

position. Note also the labels OPEN and CLOSE with the corresponding

arrows on the catches w of the battery compartment e.

Aerial

♦ Screw the screw aerial i into the aerial holder.

Silvercrest SBDB 5 A1 User Manual

Questions and Answers: