Silvercrest SBDB 5 A1

■ 16
│
GB
│
IE
│
NI
SBDB 5 A1
Manual station scan
♦ Press the TUNE+ button 9 for around 2 seconds to jump to the next avail-
able station with a higher frequency.
♦ Press the TUNE−
button 8 for around 2 seconds to jump to the next avail-
able station with a lower frequency.
NOTE
► The frequency of the station is shown on the display
1 and the
speaker6 is switched off during the station scan.
Searching for stations manually
♦ Briefly press the TUNE+ 9 or TUNE− button 8 to change the FM fre-
quency in 0.05 MHz increments. The current FM frequency is shown on the
display1.
Saving stations manually
♦ To store the current radio station manually, first briefly press the PRESET but-
ton7. The display 1 shows the preset space with the last selected radio
station (if radio stations have already been stored). If no radio stations have
yet been stored, the display shows Preset 1 empty.
♦ Press the TUNE+
9 or TUNE− button 8 to select the desired preset.
♦ Press the
ENTER/SCAN button3 to store the station in the selected
preset space. The preset space of the stored station is shown in the upper
right corner of the display
1 (e.g. P1 for preset 1).
Station information
In FM radio mode, you can show additional station information on the display 1:
♦ Briefly press the INFO/MENU button
0 repeatedly to display the
following channel information:
– Programme type (Pty)
– Signal strength (bar)
– Time/date
– Scrolling text (radio text)