Silvercrest SBMS D30 B1 - Basic operation; Select modes; Adjust the bass; Adjust the volume

32 GB/IE
NOTES:
 When turning the product on, the product
will continue in the mode it was in when it
was last turned off.
 To save energy the product will
automatically switch to standby mode when
there is no input signal (or only a weak one),
and when the CD player is not in use.
 Select modes
To get to the desired function mode, press
SOURCE
7
repeatedly or press CD, USB,
TUNER / DAB, AUX or BT
21
to select the
desired mode.
 Adjust the bass
Press BASS +/–
39
repeatedly to select a preset
sound effect: Bass 0, Bass 1, Bass 2.
 Adjust the volume
 Press VOL +/–
43
or turn VOL+ / VOL–
control
2
to adjust the volume.
 To turn the sound off, press
41
.
Press
again or press VOL +/–
43
or turn
VOL+ / VOL– control
2
to resume normal
volume.
 Volume memory
 The last used volume level will be
automatically stored.
 Select the equaliser
 Press EQ
13
/
40
repeatedly to select:
[POP] – [CLASSIC] – [ROCK] –
[JAZZ] – [FLAT].
 Adjust the brightness
 Press DIMMER
35
to select the brightness
level.
 Set the clock
Setting of the clock can only be done in STANDBY
mode.
 In STANDBY mode, press and hold
CLOCK
32
until the hour digits are flashing.
 Press
,
27
to adjust the hour digits. Press
CLOCK
32
to confirm. The minute digits are
flashing.
 Press
,
27
to adjust the minute digits.
Press CLOCK
32
to confirm.
NOTE: Each activated state will be cleared
if any buttons are not pressed within
20 seconds.
 Toggling between 12/24 hour formats:
During time setup, press
15
or
42
.
NOTE: If the product is unplugged or if
a power failure occurs, all setups of the
product will be erased.
NOTE: While the DAB mode is selected, the
clock is set automatically.
Time display
Press CLOCK
32
to show the current time on the
display for a few seconds.
 Set the alarm timer
NOTE: The clock must be correctly set for
the timer to operate correctly.
 In STANDBY mode, press and hold
TIMER
38
until the hour digits flash on the
display.
 Press
,
27
to adjust the hour digits. Press
TIMER
38
to confirm. The minute digits will
flash on the display.
 Press
,
27
to adjust the minute digits.
Press TIMER
38
to confirm. BUZZER
flashes on the display.
 Press
,
27
to select
FM / DAB / CD / USB / BUZZ mode. Press
TIMER
38
to confirm. The display will show
the volume level.
 Press
,
27
to adjust the volume. Press
TIMER
38
to confirm.
Short press
TIMER
38
Description Display
1x Timer on
2x Timer off –
NOTE: The operating time to set each step
must not take longer than 20 seconds or it
will return to time display.