37 GB/IE
DAB operation
DAB Full Scan
The FULL SCAN will search for the entire DAB
Band III channels. After the scan has finished,
the first alphanumerically found station will be
automatically selected.
Press MENU
30
button, and then press the
/ button
27
to select FULL SCAN,
and then press the
15
button to confirm.
During the scan, the display will show
SCAN ##.
Once the scan has finished, the unit will
show the total number of the station, and
then broadcast the first alphanumerically
found station.
Manually Tuning In DAB
Radio Stations
As well as the auto scan function, you can
manually tune them in. You will need to know
which multiplex the station you are looking for is
in.
Press MENU
30
button, and then press the
/ button
27
to select MANUAL,
and then press the
15
button to confirm.
Press the
/ button
27
to select DAB
stations from 5A to 13F.
Press the
15
button to confirm.
DRC Setting
You can set the DRC (Dynamic Range
Compression) to High, Low or Off. This will reduce
the volume of loud sounds and increase the
volume of quiet sounds.
Press MENU
30
button, and then press the
/ button
27
to select DRC, and
then press the
15
button to confirm.
Press the
/ button
27
to select
HIGH / LOW / OFF, and then press the
15
button to confirm.
Saving Preset Stations
You can store up to 30 of your favorite stations to
the memory. This will enable you to access your
favorite stations quickly and easily.
To store a preset, you must first be listening
to the station that you would like to save.
Press the PROG
44
button on the remote
control. The display will show "## Empty",
and the preset number will flash.
Press the
/ button
27
on the remote
control to select your desired station preset
number.
Press the PROG
44
button to confirm your
station, the display will show "STORED".
Recalling a Preset Station
Once you have saved a station to one of the
preset buttons, you can recall it by pressing
the
/ button
27
on the remote
control to select your desired preset number.
Preset number and station name will show
on the display to indicate the preset station
you are listening to.
NOTE: Number keys can only be used after
saving the preset stations.
DAB Display Modes
Every time you press INFO
26
on the unit, the
display will cycle through the following display
modes. The information is displayed on the lower
segment of the display.
DLS (Dynamic Label Segment)
Dynamic label segment is a scrolling message
that the broadcaster may include with their
transmissions. The message usually includes
information, such as program details etc.
Programme Type
This describes the style of the programme that is
being broadcast. Multi plex Name / Frequency A
multiplex is a collection of radio stations that are
bundled and transmitted on one frequency. There
are national and local multiplexes. Local ones
contain stations that are specific to that area. The
frequency of the present station will be displayed.
NOTE: DAB – unlike normal radio, groups
together several radio stations and transmits them
on one frequency.
Signal Error/ Signal Strength
The error is shown as a number. If the number is 0,
it means the signal received is error free and the
signal strength is strong. If the error rate is high, it
is recommended to reposition the radio aerial or
To Next Page
Loading...
