SBTF 10 D4
■ 64
│
GB
│
MT
♦ Press the
button again for about 3 seconds to
switch off the hands-free set. You will hear a low beep
and the operating/charging LED
lights up briefly
orange before going out completely. The hands-free set
is now switched off.
Pairing the hands-free set with a compatible
mobile phone
Before you can use the hands-free set, you must pair it with a
compatible mobile telephone.
♦ Switch the hands-free set on. After a short time, the op-
erating/charging LED
flashes alternately blue and
orange. You will hear two high beeps. The hands-free
set is now in pairing mode for about 2 minutes. If the
pairing does not happen within this time, you will hear
a low beep and the hands-free set switches off.
♦ Set the mobile telephone so that it scans for Blue-
tooth
®
devices. A detailed description of how to do
this can be found in the operating instructions for your
mobile telephone.
♦ Select the entry SBTF 10 D4 from the list of found de-
vices on your mobile phone to pair the two devices. The
name of the hands-free set SBTF 10 D4 now appears
on the list of paired devices on your mobile phone.
NOTE
► If you are asked to enter a PIN during pairing, enter
0000.
► If the pairing is successful, you will hear a short beep.
♦ The hands-free set is now in standby mode and the
operating/charging LED
flashes blue every 10 sec-
onds. If the connection to the mobile phone is lost, the
operating/charging LED flashes briefly blue every
10 seconds.