Silvercrest SBZBK 850 A1 - Emptying the dust container; Cleaning and care

12 GB
The following accessories can be attached to
the nozzle holder
[] when not in use:
–
[] Upholstery nozzle
–
[] Crevice nozzle
–
[] Furniture brush
 Switching on/off
 Pull the power plug[9] out of the housing, at
least until the yellow marking. When the red
marking appears, the end of the power cord
has been reached. Do not pull out the power
plug any further (Fig. F).
 Connect the power plug
[9] to a socket-
outlet.
 Switching on/off: Press the on/off switch
[] once (Fig. G).
 Disconnect the power plug
[9] from the
socket-outlet if you do not use the product.
 Winding up the power cord
[9]: Press the
cable winder button
[7] (Fig. H).
NOTE: Hold the power cord [9] with one
hand. Guide the power cord while it is being
wound up.
 Increasing/decreasing
suction power
 Adjust the suction power with the secondary
air regulator
[] (Fig. I).
 Emptying the dust container
NOTES:
 Empty the dust container
[4] outdoors if
possible, since emptying can lead to a cloud
of dust.
 Empty the dust container
[4] at regular
intervals. Otherwise the product could be
damaged.
 Press the dust container release
[6]. Lift the
dust container
[4] from the product using the
handle
[5] (Fig. J).
 Hold the dust container
[4] over a waste bin.
 Press the bottom release
[] on the side of
the dust container
[4] to open the bottom
and thus discharge the dust (Fig. K).
 Close the bottom. The bottom release
[]
must audibly lock in place.
 Insert the dust container
[4] into the product.
The dust container release
[6] must audibly
lock in place (Fig. L).
 Cleaning and care
m
DANGER! Risk of electric shock!
Disconnect the power plug
[9] from the
socket-outlet before cleaning the product.
Never touch the power plug with moist or
wet hands.
Always keep the power plug and power
cord dry.
m
WARNING! Risk of electric shock!
Never immerse the electric parts of the
product in water or other liquids. Never hold
the product under running water.