Silvercrest SCUR 3 A1 - Radio Station Management; Saving Stations Manually; Recalling Stored Stations; Mono Reception for Clearer Audio

GB
│
MT │ 43 ■
SCUR 3 A1
onds to set the volume with the −VOL+/ І◄◄ TUNE ►►І dial  again.
Saving stations manually
♦ Use the −VOL+/ І◄◄ TUNE ►►І dial to set the desired station.
♦ Press the CLOCK/MEMORY button
6until "MEMORY" and the pro-
gramme space (e.g. P01) flash on the display
.
♦ Turn the −VOL+/ І◄◄ TUNE ►►І dial
 to the left or right to select the
desired programme space (P01 to P20).
♦ Press the CLOCK/MEMORY button
6 again to save the station in the
desired programme space.
♦ Repeat these steps to save up to 20 stations. The same station can be saved
in more than one programme space.
Calling up the stored station
♦ To call up a stored station, press the CLOCK/MEMORY button 6 while in
radio mode and then turn the −VOL+/ І◄◄ TUNE ►►І dial
 to the right
or left to select a station.
♦ Alternatively, press the CLOCK/MEMORY button
6 several times while in
radio mode until the desired station is shown.
Receiving stations in mono
It is sometimes possible to improve the playback quality of stations with a poor or
unstable signal strength by switching from stereo to mono playback.
♦ Use the ■ ST/MONO button
 to switch between mono and stereo play-
back. If stereo playback is activated, "((ST.))" appears on the display

when a stereo radio station is received.
NOTE
► To improve FM reception quality, you can also try repositioning the wire
aerial , and/or the device.