■ 46 │ GB
│
MT
SCUR 3 A1
♦ Once the programmed sequence has played completely through, CD play-
back stops and "MEMORY" appears again on the display
. Press the ►/
II/SCAN/AMS button
again to play back the programmed sequence
again.
NOTE
► To delete a programmed sequence of tracks, press the ■ ST/MONO
button twice during CD playback or use the /SOURCE button 0to
switch the device into standby mode.
► During CD playback, or while playback is paused, you can jump to another
programmed track by pressing the −VOL+/ І◄◄ TUNE ►►І dial
once
briefly and then turning it to the left or right.
Alarm function
The device has two alarms: "AL 1" and "AL 2". You can programme an alarm
sound or playback of the last selected radio station or a CD at a certain time.
NOTE
► If no setting is made within 10 seconds while in setting mode, the setting
process is cancelled and the device exits the settings menu.
Setting the alarm time
♦ The device must be standby mode. Press the /SOURCE button 0 for
longer than 2 seconds to switch off the device, if necessary.
♦ Press the ALARM button
. for longer than 2 seconds until "AL 1" or "AL 2"
flashes on the display
.
♦ Use the −VOL+/ І◄◄ TUNE ►►І dial
to choose between the alarm
functions "AL 1" and "AL 2".
♦ Press the ALARM button
. to confirm the selection. The hour "0" flashes
on the display.
♦ Turn the −VOL+/ І◄◄ TUNE ►►І dial
to the left or right to set the hours.
Then press the ALARM button
. to save the setting. The minutes ":00"
flash.
♦ Turn the −VOL+/ І◄◄ TUNE ►►І dial
to the left or right to set the
minutes. Then press the ALARM button
. to save the setting. The symbols
for the alarm mode appear on the display
and the symbol for the active
alarm mode flashes.
♦ Turn the −VOL+/ І◄◄ TUNE ►►І dial
to the left or right to select the
desired alarm mode:
–
Alarm with alarm tone
– Alarm with CD player
–
Alarm with radio