Silvercrest SDR 15 A1 - Using the alarm; Setting the alarm

EN – 85
press and hold the SELECT controller until pairing mode restarts.
You can control how tracks are played, the volume and a range of spe-
cial functions on your external device and on the DAB radio. What
functions are available is dependent on your external device and the
software that you use.
• Turn the
-VOLUME+ controller to increase or decrease the vol-
ume.
• Press or hold the
SELECT controller to start playback.
• Use the
/ buttons or turn the controller to go back to the previ-
ous track or skip to the next track.
16. Using the alarm
The device has two alarm functions, using either an alarm tone or the
radio as a wake-up call. You can also set the alarm to start on certain
days or daily.
16.1. Setting the alarm
 Press the button. The general alarm menu opens.
 Use the
/ buttons or turn the controller to select ALARM 1
or
2.
 Press the
SELECT controller to confirm your selection.
 Then use the
/ buttons or turn the SELECT controller to set
the desired wake-up time (hour
0 - 23) and press the SELECT
controller to confirm your selection.
 Use the
/ buttons or turn the SELECT controller to set the de-
sired wake-up time (minutes
0 - 59) and press the SELECT con-
troller to confirm your selection.
 Use the
/ buttons or turn the SELECT controller to set the de-
sired wake-up time (in minutes) and press the
SELECT controller
to confirm your selection.