Silvercrest SDR 15 A1 - Stopping the alarm;activating the snooze function; Sleep timer

EN – 87
16.2. Stopping the alarm/activating the
snooze function
 When the alarm sounds and the display flashes, you can end the
alarm by pressing either the button or the button.
 Pressing the
controller activates the snooze function. A 15-minute
countdown takes place on the display. After this, the alarm sounds
again.
The controller can be pressed several times to select the fol-
lowing snooze durations:
15 minutes, 30 minutes, 45 minutes, 60 minutes, 90 minutes or
120 minutes.
 The snooze function can be cancelled by briefly pressing either the
button or the button.
 Pressing the
SELECT controller while the snooze function is active
will reset the snooze duration to 15 minutes.
16.3. Sleep timer
It is possible to programme a sleep timer on the device. After the set
time, the device automatically switches to standby mode.
 When the device is in use, press and hold the
MENU/INFO/
button until the menu is shown on the display.
 Press the
/ button or turn the controller to select <System>.
 Then press the
SELECT controller to select the system settings.
 Press the
/ button or turn the controller to select <Sleep>.
 Then press the
SELECT controller to select the sleep timer.
 Press the
/ button or turn the controller to select the desired
duration. The following can be selected:
<
15 MINUTES>, <30 MINUTES>, <45 MINUTES>,
<
60 MINUTES>, <90 MINUTES>, <120 MINUTES> or
<
SLEEP OFF> to disable the sleep timer.