18 GB/IE/NI
indicates the progress of the DAB+ station scan. The number
above the progress bar indicates how many DAB+ stations have been
found.
After the DAB+ station scan has completed, the product will select
the first available DAB+ station and start playing it. By default, the
DAB+ stations are listed in numerical and alphabetic order.
Press the button
8
to set the product to standby mode. The
colour LCD
1
shows the current date and time
1b
, as well as
the alarm settings for alarm 1
1g
and alarm 2
1f
.
Set the main switch
5
at the back of the product to position
“Off“ to switch the product all the way off.
Note: When the power supply
19
is plugged into a mains socket it
uses a small amount of electricity, even if the product is not connected
to the power supply
19
or is switched off.
Switching on / off when battery powered:
Fully extend the antenna
7
for good reception.
Set the main switch
5
at the back of the product to position “On“.
Then press the button
8
to switch the product on. When using the
product for the first time it will automatically scan for DAB+ stations
after being switched on. After the DAB+ station scan has completed,
the product will select the first available DAB+ station and start
playing it. By default, the DAB+ stations are listed in numerical
and alphabetic order.
Press the button
8
to switch the product off.
Set the main switch
5
at the back of the product to position “Off“
to switch the product all the way off.
Note: The station list is automatically saved so the product does
not need to scan for DAB+ stations the next time it is switched on.
To Next Page
Loading...
Need help?
General
