EasyManuals Logo

Silvercrest SEM 1100 C3 User Manual

Silvercrest SEM 1100 C3
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
12 
GB
IE
SEM 1100 C3
7) As soon as the green “Espresso” control lamp t lights up continuously,
press the “Espresso” button 3. Let the water run through for about 1
minute.
NOTE
You may need to empty the cup in between. Interrupt the process by pressing
the "Espresso" button
3. Empty the cup and press the "Espresso" button
3 again so that water flows through the appliance.
8) After about 1 minute, stop the pump by pressing the “Espresso” button
3
again.
9) Wait until the “Espresso” control lamp t lights up continuously (if it is not
already lit). The warming-up is concluded. You can now prepare espresso.
Heating up before every use
Before you can prepare an espresso or cappuccino, the appliance must be
heated up.
1) Switch the appliance on using the On/Off switch 1. The red operating
lamp z lights up. The “Espresso” control lamp t flashes green. Make sure
that the steam control 7 is turned in the direction of the
“▯”
as far as the
stop.
2) Place the sieve holder i in the appliance by inserting the “INSERT” mark,
which is located next to the hot water shower r, into the appliance and then
turning it clockwise until the handle of the sieve holder i is facing the front
(“LOCK” mark).
3) Press the “Espresso” button
3 so that the appliance draws water from
the water tank 9. As soon as water starts exiting the openings in the sieve
holder, press the “Espresso” button 3 again to stop the pump.
4) Wait until the “Espresso” control lamp t lights up continuously.
5) Press the “Espresso” button
3 again and allow hot water to flow
through for 20 seconds before stopping the pump again.
The preheating process is completed. You can now make an espresso/cappuccino.
Preparing espresso
NOTE
Always ensure that the espresso sieve o p is clean and free of coffee
powder residues.
1) When the appliance is heated up:
To prepare an espresso, place the small espresso sieve p into the sieve
holder i.
To prepare two espressos, place the large espresso sieve o into the sieve
holder i.
IB_353468_SEM1100C3_LB8.indb 12 22.12.2020 08:57:02

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SEM 1100 C3 and is the answer not in the manual?

Silvercrest SEM 1100 C3 Specifications

General IconGeneral
BrandSilvercrest
ModelSEM 1100 C3
CategoryCoffee Maker
LanguageEnglish

Related product manuals