GB
│
IE
│
NI
│
25 ■SEMM 1470 A1
6) Place a suitably large, empty container onto the drip grille and move the
milk nozzle so that it points into the container.
7) Insert the plug into a mains power socket and switch on the appliance using
the on/off switch %.
8) Wait until all control lamps light up permanently.
9) Set the “Milk quantity” knob to the position “Clean”
.
10) Press the “Large” latte button
2x in a row. The control lamps of
the “Large”
and “Small” cappuccino buttons ! , as well as the
“Large”
and “Small” latte buttons 3 flash alternately and hot
steam comes out of the milk nozzle .
11) Wait until no more steam comes out of the milk nozzle . If you want to
stop the cleaning process at anytime, press the “Large” latte button
.
12) Remove the milk tank and empty out any remaining water.
13) Switch the appliance off using the on/off switch %.
NOTE
► If you want to descale the milk nozzle and the milk tank add a little
standard commercial descaler for coffee machines to the milk tank and
proceed as described above. You should also observe the instructions for
the descaler.
► After descaling, clean once again using clean water only.
NOTE
The milk tank is suitable for cleaning in the dishwasher. Make sure
that the milk tank does not get jammed in the dishwasher.
For additional cleaning, you can remove the milk nozzle :
1) Take off the milk tank lid .
2) Move the milk nozzle into an upright position so that the milk nozzle lever +
is pointing directly upwards.
To Next Page
Loading...
