Silvercrest SEMM 1470 A1 - Page 29

■ 26
│
GB
│
IE
│
NI SEMM 1470 A1
3) Then press the positioning lever + and the milk nozzle at the same time
towards the recess on the milk tank lid  so that they disconnect.
4) Pull the milk nozzle  with the positioning lever + downwards and out of
the milk tank lid .
5) Undo the silver attachment on the milk nozzle  (see section “Setting the
milk nozzle”) and pull it downwards and off.
6) Clean the silver attachment and the milk nozzle  that you have removed
from the milk tank lid  along with the positioning lever + in warm water
with a little washing-up liquid. Rinse all parts afterwards with plenty of clean
water.
7) Afterwards, replace the silver attachment onto the milk nozzle  and set it
at the desired height (see section “Setting the milk nozzle”).
8) Push the milk nozzle  and the positioning lever +back into the milk tank
lid  and push the connector assembly all the way back into the appliance.
For thorough cleaning, the connecting plug can be removed from the milk tank
lid:
1) Turn it towards the
symbol and pull it out.
2) Clean the connecting plug with tap water.
Afterwards, dry it thoroughly.