■ 8
│
GB
│
IE
│
NI
SHAZ 22.2 B2
Before first use
♦ Remove all packaging materials and any protective films from the device.
♦ Fit the wall bracket f as described in the section "Fitting the wall bracket".
♦ Press the HEPA filter i and the filter holder z a little way into the dirt
container t. These may have worked loose during transport and thus
not be positioned correctly inside the dirt container t.
♦ Place the dirt container t on the hand element 4:
– Push the plastic tab on the underside of the dirt container t into the
recess on the hand element 4. Allow the "MOVE" u release button
on the upper side of the dirt container t to click audibly into the catch
on the hand element 4.
NOTE
► To remove the dirt container t from the hand element 4, push the
"MOVE" u release button downwards and remove the dirt container t.
♦ Push the suction pipe 6 onto the hand element 4 so that the contact pins
on the suction pipe 6 slide into the socket on the hand element 4.
The "PUSH" 5 release button should click audibly into place.
♦ Attach the floor nozzle 8 onto the suction pipe 6 in the same way.
NOTE
► To remove the suction pipe 6 or the floor nozzle 8 again, press the
respective "PUSH" 5/7 release button and pull the corresponding parts
apart.
♦ Place the appliance onto the wall bracket f and then put it into a corner or
lay it flat on the floor so it cannot tip over.
Fitting the wall bracket
DANGER – ELECTRIC SHOCK!
► Before drilling, ensure that there are no electrical cables or water pipes in the
wall. Drilling into a live electric cable can be potentially fatal!
♦ Push the accessories holder d onto the appropriate slots on the wall
bracket f.
To Next Page
Loading...
