■ 12
│
GB
│
IE
│
NI
SHAZ 22.2 B2
♦ To empty the dirt container t, hold it over a rubbish bin or similar and
press the "PUSH" r release button. The lid e of the dirt container flips up.
Empty out the dirt container t and flip the lid e closed (it should click into
place).
♦ Pull the HEPA filter i together with the filter holder z out of the dirt
container t.
♦ Remove the HEPA filter i from the filter holder z and tap out both parts
over a rubbish bin. If necessary, you can rinse out the filter holderz and
the HEPA filter i with fresh water. Before replacing the parts ensure that
they are completely dry.
♦ Replace the HEPA filter i in the filter holder z (note the recesses on the
holder).
♦ Push the filter holder z back into the dirt container t. Note the guide rails
on the holder as well as the recesses on the dirt container t.
♦ Replace the dirt container t on the hand element 4.
NOTE
► Clean the two dust filters w on the left and right of the hand element 4
regularly. To remove them, press the release buttons and pull out the filters.
Remove the dust filters w and tap them out. Replace the filters before re-using
the appliance.
Cleaning the floor brush
To achieve the best results, the electric floor brush 0 should be regularly
checked for blockages and any hairs, threads or dirt should be removed.
NOTE
► If the floor nozzle 8 is blocked so that the floor brush 0 can no longer
rotate, the appliance will switch off. The LEDs start to flash alternately. If this
happens, remove the blockage as described below. Afterwards, you need
to push and release the On/Off switchq once before you can use the
appliance again.
To simplify cleaning, the floor brush 0 can be removed:
♦ If you have not already done so, disconnect the appliance from the mains
adapter gor lift it off the wall bracket f.
♦ Remove the floor nozzle 8 from the suction pipe 6 or the hand element 4.
♦ Push the release switch 9 under the floor nozzle 8 as far as the stop.
The floor brush 0 can now be removed.
To Next Page
Loading...
