Silvercrest SHAZ 22.2 B2 - Cleaning the Appliance Housing; Troubleshooting Guide; Appliance Not Working Issues; Weak Suction Diagnosis

GB
│
IE
│
NI
│
13 ■
SHAZ 22.2 B2
♦ To replace the floor brush 0 after cleaning, proceed as follows:
– Push the release button 9 back outwards.
Start by pushing one end of the floor brush 0 onto the drive shaft on
the opposite side of the switch 9. Note that only one side of floor
brush 0 fits onto the drive shaft.
– Now push the other end of the floor brush 0 into the appropriate
recess under the release switch 9 and then release this.
♦ Ensure that the floor brush 0 is fitted correctly before using the floor
nozzle 8 again.
Cleaning the appliance
♦ Clean the housing and the attachments with a slightly damp cloth.
For stubborn soiling use a mild detergent on the cloth.
♦ Dry all parts thoroughly before using the appliance again or storing it.
Troubleshooting
Problem Cause The solution
The appliance is
not working.
The battery is empty. Charge the appliance.
The appliance is
defective.
Contact the Customer Service
department.
The suction is
weak.
The battery is almost
flat.
Charge the appliance.
The suction opening
is blocked.
Remove the blockage.
The filters w/i are
too dirty.
Clean the filters w/i.
Dust is escaping
from the appli-
ance.
The dirt container t
is not fitted properly.
Check whether the dirt containert
is correctly fitted or the lid e is
correctly closed.