Silvercrest SHAZ 22.2 B2 - Operation; ECO Mode Functionality; Cleaning Procedures; Emptying Dirt Container & Filter Cleaning

GB
│
IE
│
NI
│
11 ■
SHAZ 22.2 B2
Operation
CAUTION!
► The suction opening must always be kept free of blockages. Blockages lead
to overheating and damage to the motor.
NOTE
► If the floor nozzle 8 is blocked so that the floor brush 0 can no longer
rotate, the appliance will switch off. The LEDs start to flash alternately. If
this happens, remove the blockage as described in the section “Cleaning
the floor brush”. Afterwards, you need to push and release the On/Off
switchq once before you can use the appliance again.
♦ If you have not already done so, disconnect the appliance from the mains
adapter gor lift it off the wall bracket f.
♦ Fit the required attachment as necessary. See also the section "Fitting/
removing attachments".
♦ Press the On/Off switch q to switch the appliance on. As long as you hold
down the switch q, the appliance will keep running. The indicator light 3
lights up.
ECO mode
When possible, use the energy-efficient and low-noise ECO mode.
Press the ECO mode button 2 to activate ECO mode permanently.
The button lights up. This also works during operation.
Press the ECO mode button 2 again to deactivate ECO mode.
Cleaning
CAUTION! PROPERTY DAMAGE!
► Do not use aggressive, chemical or abrasive cleaning agents. These could
damage the outer surfaces of the appliance.
Emptying the dirt container and cleaning the filter
NOTE
► To achieve the best results, empty the dirt container t and clean the
HEPA filter i regularly.
♦ If you have not already done so, disconnect the appliance from the mains
adapter gor lift it off the wall bracket f.
♦ Disconnect the dirt container t from the hand element 4 by pushing the
"MOVE" u release button downwards and pulling off the dirt container t.