EasyManua.ls Logo

Silvercrest SHBSP 800 A1 - Electric Shock and Battery Safety

Silvercrest SHBSP 800 A1
201 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
36
GB
DANGER! Risk of electric shock
~ Never put the device into operation if the device, the USB plug-in
power unit or the USB cable is visibly damaged or if the device had
been dropped.
~ Connect the USB cable to the device before plugging the USB plug-
in power unit into a wall socket.
~
Only connect the
USB plug-in power unit
to a properly installed easy
to access wall socket which supplies voltage matching the rating plate.
The wall socket must continue to be easily accessible after the device is
plugged in.
~ Ensure that the USB cable cannot be damaged by sharp edges or
hot surfaces.
~ Ensure that the USB cable is not trapped or crushed.
~ When removing the USB plug-in power unit from the wall socket, al-
ways pull the power unit and never the USB cable.
~ Pull the USB plug-in power unit out of the wall socket, …
after every use,
after each charging process,
if there is a fault,
before connecting the device to the USB cable,
before you clean the device and
during thunderstorms.
~ To avoid any risk, do not make modifications to the device. Repairs
must be carried out by a specialist workshop or the Service Centre.
DANGER from batteries
~ Do not expose the device to direct sunshine or heat. The ambient
temperature should not be lower than 0 °C or higher than +40 °C.
~ The charging contacts on the device must not be connected by me-
tallic objects.
~
The battery
may only be charged with the original accessory (USB
plug-in power unit).
~ Protect the battery against mechanical damages. Fire hazard!
__291948_Haarschneider_Autokamm_B8.book Seite 36 Dienstag, 19. Dezember 2017 7:42 19

Table of Contents

Related product manuals