48
GB
6. Figure C: put the shaving head|13 from the top onto the hair and
beard trimmer|4. Mind the two small guide rails to the right and left
of the hair and beard trimmer.
7. Press the shaving head|13 down until it firmly locks into position.
11. Storage and transport lock
• For storage, use the supplied travel protection bag
|
24.
• Activate the transport lock for the transport:
- Press and hold the on/off switch|7 for approx. 3 seconds.
- The lock symbol|20 flashes before the display|5 goes off.
NOTE: if the device is connected to the mains power supply, it is impos-
sible to activate the transport lock.
• To deactivate the transport lock, you have two options:
- Press the on/off switch|7 again and hold it for approx.
3 seconds. The device is switched on and the display of the bat-
tery capacity|16 appears.
- Connect the device with the USB cable|9 to the mains power sup-
ply.
__291948_Haarschneider_Autokamm_B8.book Seite 48 Dienstag, 19. Dezember 2017 7:42 19
To Next Page
Loading...
Need help?
General
