45
GB
6.6 Controlling the speed
NOTE: the setting of the speed is only possible while the device is run-
ning.
1. Press the on/off switch|7 repeatedly until the cutting length|17 is
displayed.
2. Press the on/off switch|7 again to start the device. The speed|18
appears on the display.
3. Use the buttons ST|6 to set the desired speed. The more segments
of the speed|18 are displayed, the higher the speed.
7. Cutting hair
NOTES:
• The hair to be dressed must be dry.
• The cutting length may deviate depending on the cutting angle.
• Place a hairdressing cape around throat and neck to prevent cut-off
hair from dropping into the collar.
• Comb the hair well.
• First, start with a longer cutting length and then, in the course of the
cutting process, use progressively shorter cutting lengths.
• Start by cutting the hair in the neck or on the sides and cut towards
the centre of the head. Then, cut the front section of the hair towards
the centre of the head.
• Hold the hair and beard trimmer|4 in such a way that the comb at-
tachment
|
1
,|
2
or|
14 lies as flat as possible on the head. Move the
device evenly through the hair.
• If possible, cut against direction of hair growth.
• In order to catch all the hair, move the hair and beard trimmer|4
several times through each section of hair.
• Comb the hair repeatedly and well.
__291948_Haarschneider_Autokamm_B8.book Seite 45 Dienstag, 19. Dezember 2017 7:42 19
To Next Page
Loading...
Need help?
General
