42
GB
6.4 Switching on and off
Standby mode
When switching on, you are initially switching the device into the standby
mode. In standby mode the device is not yet ready for operation. You can
set the selector switch|11 for the attached comb attachment|1,|2 or|14
and the cutting length for the comb attachments
|
1
and|
14
(see “Cutting
length / comb attachments” on page 43).
After approx. 1 minute without action, the device switches off automati-
cally from standby mode.
Switching on
1. Press the on/off switch|7 once to switch the device into the standby
mode. The display of the battery capacity|16 appears. After ap-
prox. 2 seconds, the cutting length|17 will be displayed.
2. Press the on/off switch|7 again to start the device. The speed|18
appears on the display.
Now, the setting of the speed is possible (see “Controlling the
speed” on page 45).
Stopping device / Switching off automatically
• Press the on/off switch|7 to stop the device and switch it into the
standby mode.
• After 10 seconds without pressing a button, the display|5 will be
dimmed and the battery capacity|16 is displayed.
• After another 50 seconds without pressing the button, the device
will switch off automatically. The display|5 goes off. If applicable,
the comb attachment
|
1
/
14
is retracted.
NOTE: press the on/off switch|7 to switch the device into the standby
mode, if the display|5 is dimmed and the battery capacity|16 is dis-
played.
__291948_Haarschneider_Autokamm_B8.book Seite 42 Dienstag, 19. Dezember 2017 7:42 19
To Next Page
Loading...
Need help?
General
