Silvercrest SKHK 40 C1 - Charging the Internal Battery

GB
│
IE
│
9 ■
SKHK 40 C1
Charging the internal battery
NOTE
►
Before using the headphones, the integrated battery must be completely
charged.
ATTENTION
► Charge the headphones only in dry indoor spaces.
► Use only the supplied USB charging cable
w to charge the headphones.
► Always disconnect the USB charging cable
w when charging is complete.
♦ Make sure that the headphones are switched off. To switch off the
headphones, press the
button 5 for about 2seconds until a beep
sounds and the operating/chargingLED0 goes out.
♦ Connect the USB plug on the USB charging cable
w to a USB mains
adapter or a USB port on your computer.
♦ Connect the micro USB plug of the USB charging cable
w to the micro
USB charging socket 9 on the headphones.
NOTE
► The operating/charging LED
0 lights up orange during charging. When
the battery is fully charged, the operating/charging LED goes out.
► Charging takes about 3.5 hours at a charging current of 500 mA. When
the battery is fully charged, you can play back music at a medium volume
(85 dB(A)) for up to 36 hours. The playback time may vary depending on
level of the volume.
► When the battery is empty, you will hear two beeps at an interval of 10 min-
utes, and the operating/charging LED 0 flashes three times orange every
15 seconds. The headphones then switch off automatically.