Silvercrest SKHK 40 C1 - Call Management; Music Playback via AUX IN

GB
│
IE
│
13 ■
SKHK 40 C1
Accepting/ending/rejecting a call
NOTE
► If you are listening to music and receive a call, you will hear the ringtone in
the headphones and playback is stopped. After finishing the call, playback
will be resumed automatically.
► You can accept/reject calls via the headphones or your smartphone. The
sound is automatically played back through the headphones.
Button 5
Function
Press 1 x briefly (for incoming call) Accept call
Press 1x briefly (during call) End call
Press and hold for approx. 2 seconds (for incoming calls) Reject call
Music playback via AUX IN
You can use the supplied audio cable e to connect the headphones to
non-Bluetooth
®
-compatible playback devices. In AUX IN mode, the head-
phones behave like normal, cable-connected headphones and can even be
used with an empty battery. The Bluetooth
®
function is deactivated and the
buttons on the headphones do not function.
♦ Make sure that the headphones are switched off.
♦ Connect the audio cable
e to the AUX IN socket 8 of the head-
phones.
♦ Connect the audio cable
e to the audio output (e.g. headphone jack)
on the playback device.
♦ Switch on the playback device and set the volume to minimum.
♦ Put on the headphones as described in the section Wearing the head-
phones.
♦ Set the desired volume on the playback device.