GB
│
IE
│
11 ■
SKHK 40 C1
NOTE
► The next time you turn on the headphones, they will automatically connect
to the last Bluetooth
®
playback device that was connected. If your
Bluetooth
®
playback device does not automatically reconnect to the
headphones, you will have to re-establish the connection manually. A de-
tailed description of how to do this can be found in the operating manual
for your Bluetooth
®
playback device.
► If no Bluetooth
®
connection can be made within 6 minutes, pairing mode
ends and the headphones switch off automatically.
► Ensure that the headphones are no more than 10 metres away from the
Bluetooth
®
playback device. Make sure that there are no barriers or
electronic devices placed between them.
► As soon as you connect the AUX IN socket 8 to the audio cable e,
the Bluetooth
®
function is deactivated and the headphones change to
AUX IN mode. The Bluetooth
®
function can only be reactivated once you
remove the audio cable e from the AUX IN socket 8.
Music playback via Bluetooth
®
The following music playback functions are only available when the headphones
and the playback device are connected to each other via Bluetooth
®
.
NOTE
► It may be the case that not all functions will be supported depending on
the playback device used and its operating system.
Key Function
5
► Press briefly to play/pause the music.
4
► Press briefly to increase the volume. When you reach
the maximum volume you will hear a beep.
► Press and hold to jump to the next track.
6
► Press briefly to decrease the volume. When you reach
the minimum volume,
you will hear a beep.
► Press and hold to jump back to start of the track. Press
and hold again within
2 seconds to jump to the previous track.
To Next Page
Loading...
