■ 10
│
GB
│
IE
SKHK 40 C1
Handling and operation
Switching the headphones on/off
♦ Press the button
5
for about 2 seconds to switch on the head-
phones. You will hear a beep and the operating/charging LED
0
lights
up violet for approx. 2 seconds. The operating/charging LED
0
then
flashes alternately orange and blue.
The headphones are now in pairing mode.
♦ To switch off the headphones, press the button 5 again for about
2 seconds until you hear a beep and the operating/charging LED 0
goes out.
Wearing the headphones
♦ When putting the headphones on, please note the markings “R” (right)
and “L” (left) on the inside of the adjustable head band 1.
♦ Adjust the headband
1 so that it fits your head comfortably and the
earpieces 2 cover your ears.
Pairing/unpairing the headphones with a Bluetooth
®
device
Before you can use the headphones with the Bluetooth
®
function, you must pair
them with a compatible Bluetooth
®
device.
♦ Switch on the headphones as described above to activate pairing mode.
♦ Set the Bluetooth
®
playback device so that it scans for Bluetooth
®
devices. A detailed description of how to do this can be found in the
operating manual for your Bluetooth
®
playback device.
♦ Select the entry SKHK 40 C1 from the list of devices found on your
Bluetooth
®
playback device and, if required, enter the code 0000 to
connect the two devices. If the pairing is successful, you will hear a rising
series of beeps and the operating/charging LED 0 flashes blue twice at
3-second intervals.
♦ To terminate the Bluetooth
®
connection, either disable the Bluetooth
®
function on the Bluetooth
®
playback device or hold down the
Bluetooth
®
pairing button 7 for about 2 seconds until the operat-
ing/charging LED 0 flashes orange and blue alternately. The headphones
are now in pairing mode again.
♦ Alternatively, switch the headphones off as described above to deacti-
vate the Bluetooth
®
function.
To Next Page
Loading...
