Silvercrest SKHO 50 B2 - Setting up; Unpacking; Check package contents; Charging the internal battery

■ 8
│
GB
│
IE
SKHO 50 B2
Setting up
Unpacking
♦ Unpack all parts of the device from the packaging and remove all packaging materi-
als.
Check package contents
(See fold-out page for illustrations)
The following components are included in delivery:
● Bluetooth
®
headphones
● USB charging cable (Micro USB to
USB Type A)
● Audio cable (3.5 mm jack plug)
● Quick start guide
● These operating instructions
NOTE
► Check the package for completeness and signs of visible damage.
► If the delivery is incomplete or damage has occurred as a result of defective packag-
ing or during transport, contact the Service hotline (see section Service).
Charging the internal battery
NOTE
► Before using the headphones, the integrated battery must be completely charged.
CAUTION
► Charge the headphones only in dry indoor spaces.
► Use only the supplied USB charging cable
q to charge the headphones.
► Disconnect the USB charging cable
q when charging is complete.
♦ Make sure that the headphones are switched off. To switch off the headphones,
press the
button 4 for about 2seconds until a beep sounds and the operat-
ing LED7 goes out.
♦ Connect the USB plug on the USB charging cable
q to a USB mains adapter or a
USB port on your computer.
♦ Connect the micro USB plug of the USB charging cable
q to the micro USB charg-
ing socket DC IN r on the headphones.