EasyManua.ls Logo

Silvercrest SKHO 50 B2 - Handling and operation; Switching the headphones on;off; Wearing the headphones

Silvercrest SKHO 50 B2
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB
IE
 9
SKHO 50 B2
NOTE
The charging LED
t lights up orange during charging. When the battery is fully
charged, the charging LED
t goes out.
Charging takes about 2 hours at a charging current of 500 mA. When the battery is
fully charged, you can play back music at a medium volume (85 dB(A)) for up to 30
hours. The playback time may vary depending on level of the volume.
When the battery is empty, you will hear two beeps at an interval of 10 minutes, and the
charging LED t flashes three times orange every 15 seconds. The headphones then
switch off automatically.
Handling and operation
Switching the headphones on/off
Press the button
4
for about 2 seconds to switch on the headphones. You will
hear a beep and the
operating LED7
lights up violet for approx. 2 seconds. The
operating LED7
then flashes alternately orange and blue.
The headphones are
now in pairing mode.
To switch off the headphones, press the button 4 again for about 2 seconds
until you hear a beep and the operating LED7 goes out.
Wearing the headphones
When putting the headphones on, please note the markings “R” (right) and “L” (left)
on the inside of the adjustable headband 1.
Adjust the headband
1 so that it fits your head comfortably and the earpieces 2
cover your ears.

Table of Contents

Related product manuals