Silvercrest SKHO 50 B2 - Music playback via AUX IN; Storing the headphones

GB
│
IE
│
13 ■
SKHO 50 B2
Music playback via AUX IN
You can use the supplied audio cable w to connect the headphones to non-
Bluetooth
®
-compatible playback devices. In AUX IN mode, the headphones behave like
normal, cable-connected headphones and can even be used with an empty battery. The
Bluetooth
®
function is deactivated and the buttons on the
headphones do not function.
♦ Make sure that the headphones are switched off.
♦ Connect the audio cable
w to the AUX IN socket 8 of the headphones.
♦ Connect the audio cable
w to the audio output (e.g. headphone jack) on the
playback device.
♦ Switch on the playback device and set the volume to minimum.
♦ Put on the headphones as described in the section Wearing the headphones.
♦ Set the desired volume on the playback device.
Storing the headphones
Your headphones are fitted with swivelling earpieces 2, allowing them to be folded and
stored without taking up much space.
Proceed as follows to fold the headphones:
♦ Swivel both earpieces
2 so that they are inside the headband 1 (see fig. 1).
You can now store the headphones in a space-saving way.
Fig. 1